However, if there are more than a handful of interfaces, copying to the startup-config will save time. If the path worked when the command was run directly on the device, Im not sure it would be the problem in the play. Copy/Restore the configuration file from the TFTP server to a router in privileged.

You will need to configure each interface with a “no shut” (short for no shutdown).ĭoing this manually will give you the warm, fuzzy feeling of watching the interfaces come up. My playbook uses SCP (netput module) to copy images from the ansible server to my devices, I have found it a lot more stable than tftp transfers. How can a Cisco Routers Configuration be saved and then restored. When you copy into running-config, all of the interfaces will be administratively down. While it is possible to copy the config directly into the startup-config and reload the router, I like to place it into running-config directly to make sure that everything comes up as it should. It was fine at the beginning then when it was almost done I got lots of O errors.O usually indicates that a packet was received out of order and the copy process may fail.Symptoms:Switchcopy tftp: flash:Address or name of remote host 1.1.1.

This pulls the configuration out of flash and makes it the current running configuration. I were using TFTPD32 to transfer a image to Cisco 3560 switch. (No password should be required if this is an unconfigured router.) Then use the following command to load the configuration from flash: When moving the configuration to another router, physically move the flash memory, power on the router, and answer “no” to the system configuration prompt. (I try to do it whenever I make a configuration change.) (Just press Enter to continue.) This must be done on the old router. To copy the startup-config to flash as a file called backupconfig, use the following command: This simple command also provides a local backup copy of the router’s config which can save hours of work when replacing a dead router. Without this procedure, manually copying the old configuration to the new router will be necessary. When replacing a faulty router that is not completely dead, it may be possible to copy the startup configuration to the removable flash memory and swap the flash to get the new router up and configured in as short a time as possible.

Cisco copy tftp flash